사전에 방화벽이 있는 필히 확인
> KVM 에서 작업
# yum install fence-virt fence-virtd fence-virtd-libvirt fence-virtd-multicast fence-virtd-serial
# mkdir -p /etc/cluster
# cd /etc/cluster/
# dd if=/dev/urandom of=/etc/cluster/fence_xvm.key bs=4k count=1
1+0 records in
1+0 records out
4096 bytes (4.1 kB) copied, 0.000506736 s, 8.1 MB/s
# scp -r /etc/cluster/fence_xvm.key root@Node1:/etc/cluster/fence_xvm.key
root@node1's password:
fence_xvm.key 100% 4096 4.0KB/s 00:00
# scp -r /etc/cluster/fence_xvm.key root@Node2:/etc/cluster/fence_xvm.key
root@node2's password:
fence_xvm.key 100% 4096 4.0KB/s 00:00
- fence_virtd -c명령을 사용하여 /etc/fence_virt.conf파일을 만듭니다
# fence_virtd -c
Module search path [/usr/lib64/fence-virt]:
Available backends:
libvirt 0.1
Available listeners:
multicast 1.2
Listener modules are responsible for accepting requests
from fencing clients.
Listener module [multicast]:
The multicast listener module is designed for use environments
where the guests and hosts may communicate over a network using
multicast.
The multicast address is the address that a client will use to
send fencing requests to fence_virtd.
Multicast IP Address [225.0.0.12]:
Using ipv4 as family.
Multicast IP Port [1229]:
Setting a preferred interface causes fence_virtd to listen only
on that interface. Normally, it listens on all interfaces.
In environments where the virtual machines are using the host
machine as a gateway, this *must* be set (typically to virbr0).
Set to 'none' for no interface.
Interface [virbr0]: br0:1
The key file is the shared key information which is used to
authenticate fencing requests. The contents of this file must
be distributed to each physical host and virtual machine within
a cluster.
Key File [/etc/cluster/fence_xvm.key]:
Backend modules are responsible for routing requests to
the appropriate hypervisor or management layer.
Backend module [libvirt]:
Configuration complete.
=== Begin Configuration ===
backends {
libvirt {
uri = "qemu:///system";
}
}
listeners {
multicast {
port = "1229";
family = "ipv4";
interface = "virbr1"; <----- 클러스터 setup 할때 사용한 대역을 사용 virtbr0 인지 virtbr1 인지
address = "225.0.0.12";
key_file = "/etc/cluster/fence_xvm.key";
}
}
fence_virtd {
module_path = "/usr/lib64/fence-virt";
backend = "libvirt";
listener = "multicast";
}
=== End Configuration ===
Replace /etc/fence_virt.conf with the above [y/N]? y
> VM node 설정
[root@Node1# rpm -qa fence-virt
fence-virt-0.3.0-16.el7.x86_64
[root@Node1]# fence_xvm -o list
Node1 6daac670-c494-4e02-8d90-96cf900f2be9 on
Node2 17707dcb-7bcc-4b36-9498-a5963d86dc2f on
